Frequently Asked Questions
Search Results
24 FAQs matched your search criteria.
- How do I activate the repeater mode on my trunk socket (round version)?
- How to configure my firewall?
- How do I move a sensor to another room?
- How do I start the calibration procedure for my valve?
- How do I connect to the Snugr site / interface?
- How do I reset my Snugr Smart Plug (round version)?
- How do I connect my Snugr Smart Plug to my Snugr installation?
- How do I connect my valve to my Snugr installation?
- How do I connect my boiler controller (batteries) to my Snugr installation?
- How do I connect my powered boiler controller (230VAC) to my Snugr installation?
- How do I connect my On/Off relay to my Snugr installation?
- How do I connect my temperature sensor to Snugr?
- How do I connect my repeater to my Snugr installation?
- installation of the Snugr kit
- The signal from a device is weak even though a repeater is nearby, why?
- My calendar does not allow online access to the iCal file (.ics). How do I synchronise it with Snugr in this case?
- My boiler contact shows the "low battery" symbol, what should I do?
- My boiler box shows the symbol "communication delay error", what should I do?
- My boiler box indicates that it is heating in the "Parameters - Devices" page but it is not heating.
- My sensor shows the symbol "communication delay error", what should I do?
- My radiator heats up when my valve is closed
- What is "summer mode"?
- What is "maintenance mode"?
- What should I do if my Snugr box indicates a loss of communication with the servers?