How do I enable repeater mode on my “smart plug” (round version)?

This procedure enables repeater mode on a round smart plug and lets you choose the repeat level.

1) Enter “Repeater” mode

1. Press and hold the touch button for more than 25 seconds.

2. The plug cycles through several modes (shown by the red LED). Keep holding until it reaches Repeater mode (red LED flashing), then release.

2) Select the repeater mode (short presses)

1. Press the button briefly (100 to 400 ms).

2. Each short press changes the mode.

The red LED indicates the selected mode: it flashes 1, 2, or 3 times, then stays off for about 1 second.

• Mode 1: repeater off (red LED flashes once)

• Mode 2: repeater level 1 on (red LED flashes twice)

• Mode 3: repeater level 2 on (red LED flashes three times)

3) Confirm the selected mode

1. Press and hold for more than 5 seconds.

2. The green LED flashes to confirm.

Reminder about repeat levels

• Level 1: repeats messages once.

• Level 2: can repeat already repeated messages (may improve coverage, but increases radio traffic).