How do I pair my signal repeater with my Snugr installation?

A signal repeater improves the radio range between your devices (valves, sensors, etc.) and the Snugr gateway.

Important:

A repeater works even if it is not paired in Snugr.
Pairing it with your installation allows you to:
- display its signal level,
- see the last communication time,
- and change its repeat mode.

Depending on the repeater, you can usually select the repeat level:

Level 1: telegrams are repeated once.
Recommended in most cases to reduce radio traffic.
Level 2: telegrams that were already repeated can be repeated again (so a second repeat may occur).
Useful for difficult areas, but may increase radio traffic.

Pairing steps (installation wizard)

Open the Snugr interface (local or remote).
Go to Settings → Installation (installation wizard).
Click Add a device.
Select Repeater.
Make sure the repeater is not powered:
- unplug it (plug-in repeater), or
- switch off the corresponding circuit breaker/fuse (in-wall repeater).
Click Start pairing.
Power the repeater:
- plug it in, or
- turn the breaker/fuse back on.
A red LED flashes to indicate the device is operating. Wait a moment.
A message will appear in the wizard to confirm pairing is successful.

Make sure you are still within the wizard’s pairing window.
Try again, ensuring the repeater is truly unpowered when you click Start pairing, then powered immediately after.
For in-wall repeaters, check power at the breaker/fuse and confirm the LED turns on/flashes.