How do I install and pair my relay micro-module (dry contact / ON-OFF) in Snugr?

This micro-module controls equipment through a relay (ON/OFF or dry contact depending on wiring). It is powered by 230 V AC and intended for indoor use.

SIN-2-1-XX-FR (2)

Key points before installation

• Turn power off at the breaker panel before wiring.

  SIN-2-1-XX-FR (2)

• Max power: 2300 W (resistive load). Switching capability: 230 V AC – 10 A (and 30 V DC – 10 A).

  SIN-2-1-XX-FR (2)

• Heat sensitive: operating temperature -10 °C to 40 °C. Avoid hot, enclosed areas—do not install it directly behind a radiator.

  SIN-2-1-XX-FR (2)

• Install inside a compliant junction box and keep away from liquids.

  SIN-2-1-XX-FR (2)

1) Wiring (summary)

Manual terminals: N (neutral), L (line), I1/I2 inputs (optional wired switch), relay output terminals. Up to 2.5 mm² per terminal (8 mm stripping).

SIN-2-1-XX-FR (2)

Exact wiring depends on the use case.

SIN-2-1-XX-FR (2)

2) Pair the module with Snugr (installation wizard)

1. Open Snugr (local or remote).

2. Go to Settings → Installation.

3. Click Add a device.

4. Select the appropriate type (relay / controller / micro-module, depending on wording).

5. Select (or create) the room.

6. Click Start pairing.

7. The module must be powered. Enter pairing by doing 3 quick consecutive presses on the module button: the LED blinks red.

   SIN-2-1-XX-FR (2)

8. Wait for confirmation (the manual mentions about 30 seconds).

   SIN-2-1-XX-FR (2)

3) Reset (if needed)

1. Press and hold the button for more than 5 seconds: the LED blinks orange.

   SIN-2-1-XX-FR (2)

2. Then do a short press to confirm. The LED blinks red/green alternately, then turns green.

   SIN-2-1-XX-FR (2)

3. Pair again via Snugr.